고주파 변압기 제조 공정 포인트 3 케이싱

작가: 맥탑
2022-09-12
회사 뉴스 | 공통 모드 초크 | 산업 뉴스 | 변신 로봇|RJ45 connectors


High frequency 변신 로봇 General casing position rules:

ㅏ 외부: 케이싱 끝과 외부 사이의 거리PIN은 가능한 한 짧지만 케이싱이빈 용접 현상의 원인이 되는 PIN 주위에 감겨 있지 않습니다.

B 인테리어:  인피니티 월핏, 납작한 BOBBIN 약 1/2L 길이B 측벽이 있는 경우 케이싱이 정지 벽에 있어야 합니다.
The width and material of the margin tape can not be replaced arbitrarily, because the width and material of the 변신 로봇 are involved in the design of safety regulations need special attention
벽 테이프의 너비: 일반적으로 다음과 같이 높아야 합니다.권선의 높이, 권선시 가벽에 구리선이 쌓이는 것을 방지하지만 코어의 경우 때때로 높이의 1/2-3/4 정도를 포장하기 어렵지만 권선이 가벽에 쌓이지 않는 경우 원칙으로 벽.

Tips: Sometimes, if the thickness of the inlet and outlet line is affected by the casing, the method of skipping the outlet line can be adopted. ㅏt this time, special attention should be paid to the position of the casing, and there must be enough safe distance (deep into the width of the false wall).

이 점은 가벽 또는 동박과 M/F와 그 주변의 큰 간격으로 인해 때때로 가벽에 깊숙이 들어가야 하며, 가벽 또는 라인 M/T가 깊숙이 선택되어야 하고 M/T가 선택되어야 하는지 명확한 구별이 없다. /T 안전 바의 동일한 너비, 각 측정.
 
220v 12 0 12 변신 로봇
flyback 변신 로봇

 

High frequency 변신 로봇 manufacturing process points 2 Kinking

High frequency 변신 로봇 manufacturing process points 1 Winding